|
NAT problem under windows Xp - Possible solution
![[nl]](/s/countries/nl.gif) Shadow Hawkins on Friday, 23 July 2004 15:20:58
People who has the not "remembered state" of their tunnel and loses their connection after 300seconds can try this.
Run netsh
Go to Interface-->ipv6
Run the following command:
set state 6over4=enabled
NAT problem under windows Xp - Possible solution
But 6over4 (RFC2529: Transmission of IPv6 over IPv4 Domains without Explicit Tunnels) has nothing to do with 6in4 RFC1933: Transition Mechanisms for IPv6 Hosts and Routers ;)
These are two completely independent protocols both serving a different purpose.
Check the My tunnel goes down after some idletime. My tunnelendpoint also is a NAT.
|
![[ch]](/s/countries/ch.gif)
on Friday, 23 July 2004 15:38:58
Posting is only allowed when you are