This page lists routers that support IPv6 out of the box.
Note that at this time some of the popular brands, such as D-Link, Linksys and Belkin, show no signs of supporting IPv6 in the immediate future. Contacting them, or asking on the relavent forums, confirmed that they have nothing available or planned at this point. For this reason, if you wish to add IPv6 support to a router that does not officially support it, then your best best is to look at one of the third-party firmwares, such as OpenWrt, DD-WRT and Sveasoft, but note that not all routers have this option.
It is possible to configure a generalised computer, using BSD or Linux for example, to act as a router though this is outside the scope of this page.
Another note for Cisco Routers in my example configuration was that the router should be directly assigned to the internet not through NAT or anything else. It did not work although all ports were forwarded to the device. So configure your Router with a dedicated Internet-Link!!!
Just because a router supports IPv6 does not mean it will support a establishing a tunnel, so you should check that tunnelling is supported before purchasing it to connect with Sixxs. If you have any of the routers below and have been able to use it to connect to Sixxs directly (as opposed to using a secondary device), then please add a note next to it indicating that it is possible.
Home, Home Office & Small Office
|Airport Extreme||Apple||IPv6 (6to4 and manual tunnels (Teredo)), requires MacOS X or MS-Windows to configure (no web UI). PPPoE, DHCP support. Not useable with sixxs due to inability to respond to tunnel ping (sixxs uses to make sure the tunnel is up)|
|Time Capsule||Apple||IPv6 (6to4 and manual tunnels (Teredo)), requires MacOS X or MS-Windows to configure (no web UI). PPPoE, DHCP support.|
|ARxxx||Allied Telesis||Allied Telesis claims that ipv6 is enabled on its routers via a special feature licence. Configuration example for the AR740 can be found on Allied Telesis website|
|WHR-HP-AG108||Buffalo Technology||IPv6 is not indicated in the specifications, but is mentioned in the product manual|
|WZR-AG300NH||Buffalo Technology||IPv6 support is listed in the specifications|
|WBMR-G54||Buffalo Technology||IPv6 is not indicated in the specifications, but is mentioned in the product manual|
|Cisco 827H||Cisco||IPv6 Tunneling support in IP PLUS 12.4. Configuration help can be found on SixXS FAQ. (Although it supports IPv6, this IOS has limited functionalities (No Firewall, IPSEC, CBAC,...))|
|Cisco 83x||Cisco||IPv6 support in IP/FW/PLUS 3DES (k9o3sy6) 12.4 IOS. Configuration help can be found on SixXS FAQ.|
|Cisco 87x||Cisco||IPv6 support in advipservicesk9 IOS 87x (128Mb RAM/28 Flash), also in adventerprisek9 for 876 router. Configuration help can be found on SixXS FAQ. Please note that IPv6 tunneling is not available for 85x series although they are very similar to 87x.|
|ScreenOS 5.0||Juniper Networks||Full support for ipv6 in Netscreen 5XT, 204/208, 500 and 5200 (MGT1+8G), 5GT, ISG 2000. Tunnel configuration example can be found on bluerait website|
|RVS4000||Linksys||ipv6 support LAN side|
|Linux derived||Various||Other than wrt. One can configure ipv6 tunneling using SixXS FAQ on any Linux firewall router distribution. IPCop, m0n0wall, XORP.|
|Sonicwall TZ||Sonicwall||Allthough SonicOS Enhanced 4.0 supports IPv6, can't verify support for tunneling ipv6 over ipv4|
|Cisco ASA||Cisco||IPv6 support, but no IPv6-IPv4 tunneling configuration available.|
|Cisco PIX||Cisco||IPv6 support, but no IPv6-IPv4 tunneling configuration available. Now End of sale with the newer ASA series|
|Cisco 1700||Cisco||IPv6 support on advipservicesk9 and adventerprisek9 IOS. This is the minimum series, any greater series 1800, 2600, 2800, 3600, 3800+ router supports ipv6 too. Cisco is given support to ipv6 since May 2001, the first IOS release with IPv6 support was the 12.2T. Configuration help can be found here|
|JunOS||Juniper Networks||Full support for ipv6 in M-series and T-series. Configuration help can be found here|
|Sonicwall NSA series||Sonicwall||SonicOS Enhanced 5.0+ claims ipv6 prepared, can't verify if it supports tunneling ipv6 over ipv4|
Note: You are encouraged to update this list if you know of IPv6 capable routers not yet listed here.